The Plymouth arrives and we begin the soda and sandblasting process.

Leading the package tray and quater seems back in.

The bodywork process. We apply a coat of Sikkens Autosurfacer Epoxy Primer over the bare metal to seal it up. We sand that and apply the bodywork over that. After the rough bodywork and forming is done we apply 3 coats of Sikkens Colorbuild Primer, a Urethane Primer. We block that down and re-prime if necessary.

The prep and painting process. Now we start trimming out the bolt-on sheetmetal

After the final priming process we start wetsanding and prepping for paint.

Now we begin to paint. Basecoat/Clearcoat

Cutting And Buffing. We cut each panel on the car from top to bottom and buff it to perfection.